Your site complies with OSHA fall protection?

Many think that would go down with the OSHA requirements for fall protection, the number of accidents, incidents and deaths. On the contrary, OSHA reported that falls increased in recent years. Often, construction fall protection systems available, but the workers are not really, because it has trained. Another reason is that the increase in the number of accidents is because the fall protection systems in place is not installed properly. The only way toensure that the tragic incidents and crashes will not happen to follow the construction fall protection standards for occupational safety and Health Administration (OSHA) set.

May come under OSHA 29 CFR 1926.501-503, the systems will be provided by multiple systems. The railing system consists of an upper track 42 cm above the ground. Being a mid-rail should be installed halfway between the top and the earth. The toe board must be 3 and a half inches in height. Screensand network are used to replace the core of the network, provided that extend from the top of the guide on the floor.

Car Pa System

Another system is the personal fall protection. This can be a full body harness, lanyard, lifeline, connector and an anchor point capable of supporting at least 5,000 pounds. Personal fall protection must be checked before each use.

The positioning device is a harness that someone on a vertical surface like a wall of work permits, with both handsFree.

Safety monitoring system is a qualified person, other monitoring, such as working on an elevated area and warn of the danger of falling.

Another type of fall protection, the general alarm system must be installed by lines or ropes to work on the roof and that is only on low-pitched roofs there. The cables or ropes serve as a barrier for those starting work on the roof, avoiding the edges and must be on all sides and not less than 6 meters fromEdge of the roof. It must also be combined with any fall protection, in general, the security monitoring system can be used.

It 'important to OSHA fall protection on construction sites to reduce the risk of accidents and injuries. Often sites have fall protection, but are often poor, inadequate and do not provide job security. As a catastrophic consequence fell and injured workers. The employer may say that fall protectionSystem in place, but that is not the end of the story. The fall protection may be outdated or not installed properly. It 'even worse, are not adequately trained to protect workers from the incident, despite the fact that there is a use. Just because an employer has a life-line does not mean that it is not the fault of a worker's fall and injuries.

Your site complies with OSHA fall protection?